/* $NetBSD: ahbreg.h,v 1.13.4.1 2005/03/19 08:33:58 yamt Exp $ */ /*- * Copyright (c) 1997, 1998 The NetBSD Foundation, Inc. * All rights reserved. * * This code is derived from software contributed to The NetBSD Foundation * by Charles M. Hannum and by Jason R. Thorpe of the Numerical Aerospace * Simulation Facility, NASA Ames Research Center. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * 3. All advertising materials mentioning features or use of this software * must display the following acknowledgement: * This product includes software developed by the NetBSD * Foundation, Inc. and its contributors. * 4. Neither the name of The NetBSD Foundation nor the names of its * contributors may be used to endorse or promote products derived * from this software without specific prior written permission. * * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE * POSSIBILITY OF SUCH DAMAGE. */ /* * Originally written by Julian Elischer (julian@tfs.com) * for TRW Financial Systems for use under the MACH(2.5) operating system. * * TRW Financial Systems, in accordance with their agreement with Carnegie * Mellon University, makes this software available to CMU to distribute * or use in any manner that they see fit as long as this message is kept with * the software. For this reason TFS also grants any other persons or * organisations permission to use or modify this software. * * TFS supplies this software to be publicly redistributed * on the understanding that TFS is not responsible for the correct * functioning of this software in any circumstances. */ typedef u_int32_t physaddr; typedef u_int32_t physlen; /* * Offset of AHA1740 registers, relative from slot base. */ #define AHB_EISA_SLOT_OFFSET 0x0c80 #define AHB_EISA_IOSIZE 0x0080 /* * AHA1740 EISA board mode registers (relative to port offset) */ #define PORTADDR 0x40 #define PORTADDR_ENHANCED 0x80 #define BIOSADDR 0x41 #define INTDEF 0x42 #define SCSIDEF 0x43 #define BUSDEF 0x44 /**** bit definitions for INTDEF ****/ #define INT9 0x00 #define INT10 0x01 #define INT11 0x02 #define INT12 0x03 #define INT14 0x05 #define INT15 0x06 #define INTHIGH 0x08 /* int high=ACTIVE (else edge) */ #define INTEN 0x10 /**** bit definitions for SCSIDEF ****/ #define HSCSIID 0x0F /* our SCSI ID */ #define RSTPWR 0x10 /* reset scsi bus on power up or reset */ /**** bit definitions for BUSDEF ****/ #define B0uS 0x00 /* give up bus immediatly */ #define B4uS 0x01 /* delay 4uSec. */ #define B8uS 0x02 /* * AHA1740 ENHANCED mode mailbox control regs (relative to port offset) */ #define MBOXOUT0 0x50 #define MBOXOUT1 0x51 #define MBOXOUT2 0x52 #define MBOXOUT3 0x53 #define ATTN 0x54 #define G2CNTRL 0x55 #define G2INTST 0x56 #define G2STAT 0x57 #define MBOXIN0 0x58 #define MBOXIN1 0x59 #define MBOXIN2 0x5A #define MBOXIN3 0x5B #define G2STAT2 0x5C /* * Bit definitions for the 5 control/status registers */ #define ATTN_TARGET 0x0F #define ATTN_OPCODE 0xF0 #define OP_IMMED 0x10 #define AHB_TARG_RESET 0x80 #define OP_START_ECB 0x40 #define OP_ABORT_ECB 0x50 #define G2CNTRL_SET_HOST_READY 0x20 #define G2CNTRL_CLEAR_EISA_INT 0x40 #define G2CNTRL_HARD_RESET 0x80 #define G2INTST_TARGET 0x0F #define G2INTST_INT_STAT 0xF0 #define AHB_ECB_OK 0x10 #define AHB_ECB_RECOVERED 0x50 #define AHB_HW_ERR 0x70 #define AHB_IMMED_OK 0xA0 #define AHB_ECB_ERR 0xC0 #define AHB_ASN 0xD0 /* for target mode */ #define AHB_IMMED_ERR 0xE0 #define G2STAT_BUSY 0x01 #define G2STAT_INT_PEND 0x02 #define G2STAT_MBOX_EMPTY 0x04 #define G2STAT2_HOST_READY 0x01 #define AHB_NSEG 33 /* number of DMA segments supported */ struct ahb_dma_seg { physaddr seg_addr; physlen seg_len; }; struct ahb_ecb_status { u_short status; #define ST_DON 0x0001 #define ST_DU 0x0002 #define ST_QF 0x0008 #define ST_SC 0x0010 #define ST_DO 0x0020 #define ST_CH 0x0040 #define ST_INT 0x0080 #define ST_ASA 0x0100 #define ST_SNS 0x0200 #define ST_INI 0x0800 #define ST_ME 0x1000 #define ST_ECA 0x4000 u_char host_stat; #define HS_OK 0x00 #define HS_CMD_ABORTED_HOST 0x04 #define HS_CMD_ABORTED_ADAPTER 0x05 #define HS_TIMED_OUT 0x11 #define HS_HARDWARE_ERR 0x20 #define HS_SCSI_RESET_ADAPTER 0x22 #define HS_SCSI_RESET_INCOMING 0x23 u_char target_stat; u_int32_t resid_count; u_int32_t resid_addr; u_short addit_status; u_char sense_len; u_char unused[9]; u_char cdb[6]; }; struct ahb_ecb { u_char opcode; #define ECB_SCSI_OP 0x01 u_char:4; u_char options:3; u_char:1; short opt1; #define ECB_CNE 0x0001 #define ECB_DI 0x0080 #define ECB_SES 0x0400 #define ECB_S_G 0x1000 #define ECB_DSB 0x4000 #define ECB_ARS 0x8000 short opt2; #define ECB_LUN 0x0007 #define ECB_TAG 0x0008 #define ECB_TT 0x0030 #define ECB_ND 0x0040 #define ECB_DAT 0x0100 #define ECB_DIR 0x0200 #define ECB_ST 0x0400 #define ECB_CHK 0x0800 #define ECB_REC 0x4000 #define ECB_NRB 0x8000 u_short unused1; physaddr data_addr; physlen data_length; physaddr status; physaddr link_addr; short unused2; short unused3; physaddr sense_ptr; u_char req_sense_length; u_char scsi_cmd_length; short cksum; u_char scsi_cmd[12]; /*-----------------end of hardware supported fields----------------*/ struct ahb_dma_seg ahb_dma[AHB_NSEG]; struct ahb_ecb_status ecb_status; struct scsi_sense_data ecb_sense; TAILQ_ENTRY(ahb_ecb) chain; struct ahb_ecb *nexthash; int32_t hashkey; struct scsipi_xfer *xs; /* the scsipi_xfer for this cmd */ int flags; #define ECB_ALLOC 0x01 #define ECB_ABORT 0x02 #define ECB_IMMED 0x04 #define ECB_IMMED_FAIL 0x08 int timeout; /* * This DMA map maps the buffer involved in the transfer. * Its contents are loaded into "ahb_dma" above. */ bus_dmamap_t dmamap_xfer; };