# $NetBSD: Makefile,v 1.55 2013/01/26 21:37:06 adam Exp $
#
DISTNAME= qcad-2.0.5.0-1-community.src
# what to do about this numbering? RibbonSoft really seems to use four digits
# (there's a 2.0.4.7 for some platforms), though I don't know about the
# thing after the hyphen, which always seems to be 1. Can I use four digits?
PKGNAME= qcad-2.0.5.0
PKGREVISION= 6
.include "./Makefile.common"
COMMENT= 2D CAD system
GNU_CONFIGURE= yes
USE_TOOLS+= autoconf gmake pax
USE_LANGUAGES= c c++
CONFIGURE_DIRS= fparser dxflib
BUILD_DIRS= ${CONFIGURE_DIRS}
BUILD_DIRS+= qcadlib qcadcmd qcadactions qcadguiqt qcad
MAKE_ENV+= QMAKESPEC=${QTDIR}/mkspecs/default
PREPEND_PATH+= ${QTDIR}/bin
# I really want this to be post-*patch* where it makes sense, but QTDIR isn't
# available until after the wrapper phase because it depends on
# BUILDLINK_PREFIX.qt3-libs, which buildlink3 sets. Nothing is easy. :) The
# patches have replaced old hardcoded paths with fixed cookies @PREFIX@ and
# @QTDIR@. The SUBST framework will replace the cookies with the proper
# values.
SUBST_CLASSES+= paths
SUBST_STAGE.paths= pre-configure
SUBST_MESSAGE.paths= Attending to hard-coded paths.
SUBST_FILES.paths+= qcadlib/src/engine/rs_system.cpp
SUBST_FILES.paths+= qcad/src/qc_applicationwindow.cpp
SUBST_SED.paths= -e 's,@PREFIX@,${PREFIX},g'
SUBST_SED.paths+= -e 's,@QTDIR@,${QTDIR},g'
post-patch:
cd ${WRKSRC}/fparser && autoconf
cd ${WRKSRC}/dxflib && autoconf
# Just setting BUILD_DIRS would be adequate if qcad could be built with
# "prepare all" in each module, one by one. But qcad needs all modules to
# be prepare'd before any can be all'd, so prepare them here in a separate
# loop duplicated from do-build. The unmodified do-build then takes care
# of the "all". I didn't see an easier way.
pre-build:
${RUN} ${_ULIMIT_CMD} \
for d in ${BUILD_DIRS}; do \
cd ${WRKSRC}; cd "$$d"; \
${BUILD_MAKE_CMD} prepare; \
done
INSTALLATION_DIRS= bin share/qcad
do-install:
${INSTALL_PROGRAM} ${WRKSRC}/qcad/qcad ${DESTDIR}${PREFIX}/bin
cd ${WRKSRC}/qcad && umask 022 && \
pax -rwpm data fonts patterns qm ${DESTDIR}${PREFIX}/share/qcad
.include "../../x11/qt3-libs/buildlink3.mk"
BUILDLINK_API_DEPENDS.qt3-libs+= qt3-libs>=3.3.4
.include "../../x11/qt3-tools/buildlink3.mk"
BUILDLINK_API_DEPENDS.qt3-tools+= qt3-tools>=3.3.4
BUILDLINK_DEPMETHOD.qt3-tools= full # uses assistant for help
.include "../../mk/bsd.pkg.mk"
CVSweb <webmaster@jp.NetBSD.org>